Oracle 1z0-489 SPARC M6-32 and SPARC M5-32 Servers Installation Essentials Exam Practice Test

accessing a Solaris domain on another host and using ipmi tool to assign components to PDomains

using the Oracle ILOM BUI to assign components to PDomains

using Oracle Ops Center to assign components to PDomains

using the service processor ILOM command-line interface to assign components to PDomains

Visually check for the chassis serial number label at the front lower left – hand side.

Using the SP on each platform to access the ILOM, run show /system serial_ number.

Visually check for the chassis serial number label at the front upper right-hand side.

Using the SP on each platform to access the ILOM, run show /systemsystem_ identification.

Visually check for the chassis serial number label at the rear, towards the top, in the middle.

ensures all decisions about what the customer wants are clarified well before the installation starts

supports the goal of consistent, high-quality installations

provides a way to document what team performs what service

enables the customer to easily see what has been defined and make changes as needed

Always install the most recent version of patch.

Delay installation until the updated patch is published to the EIS-DVD.

Do not install the patch unless instructed to do so by an EIS Alert.

Never install patches outside of the EIS- DVD.

MOS

ASR Client

ASR Manager

SP

Always create mirrored pools, even if the controller provides H/W –based RAID. ZFS needs to be able to correct the data if it detects corruption.

If the controller provides H/W-based RAID, then it is not necessary to create mirrored pools.

If you ADD a disk to mirror the root pool, you must also manually perform aninstallboot or installgrub on that disk to make it bootable. If the root pool is initially created as a mirrored pool, this is not necessary.

For non-root pools, you must partition the disk and assign slices to various partitions.

In the case of rpool, the disks need to be sliced. It is recommended to have only a single slice of the full disk size used by ZFS on the although a small slice can be allocated for non-ZFS use (for example, SVM metabd).

This is a one-time setting.

The default setting for auto-boot? is True.

Keyswitch is set to Normal.

auto-boot? returns to its default setting at the next reset.

Keyswitch is set to Locked.

There was an error in the Oracle Solaris 11 installation process. You must re-install.

SunVTS needs to be downloaded separately from http://downloads.oracle.com.

After the system has been installed and rebooted, SunVTS and other packages can be added as described in the Solaris 11 EIS checklist.

SunVTS is no longer supported on Oracle Solaris 11.

Within a DCU, a CPU talks to another CPU directly by using the coherency switch. The SSB is not needed.

From one DCU to a different DCU, an even talks with only another even (same for odd) and hops to the odd-numbered board, if needed, on the destination DCU.

From one DCU to a different DCU, all CPUs can access all PCIe slots In the destination DCU directly in one hop.

A DCU can communicate data only with other DCUs via the BX ASICs on the SSB.

From one DCU to a different DCU, even CPUs can access ail the odd PCIe slots in the destination DCU directly in one hop.

clear faults

reset /HOSTx

boot -r

power off

keyswitch

dcus_available

dcus__assigned

expandable